web analytics

Welcome, Guest. Login / register for a free account  

Correct and Reasonable Installation of Sand Washer

5 July, 2013 at 10:27 am in Buy & Sell

No Image Available

Contact Details

lucy smith

Phone Number : 37167833171

Location : ??

Send Inquiry

Sand washing machine is suitable for construction sites, gravel plants, hydroelectric plants, concrete dam site, post pole factory on required gravel and casting sand '70', glass quartz sand and oil wells backfill pressure sand for washing, grading and dehydration. Spiral sand washing machine is arranged inclined at 15 degrees, the sink bottom is surrounded by three weir plates to form a sedimentation tank, the screw head is immersed sedimentation tanks, spiral continuous rotates driven by the motor through the reducer, the perforated plate on the bottom of the settling tank supply cleaning water. The device combines three functions of washing, dewatering, grading.Sand making equipments mainly include impact crushre, jaw crusher, hammer crusher, cone crushre,roll crusher and vibrating feeder,etc.

Installation and operation of the sand washing machine is assembled by the manufacturer, and after run-in test qualified, the whole set supply, the user should be carefully examined upon receipt. In order to detect and remove potential problems in transit, machine installation, adjustment and operation should pay attention to:

1. Because this machine torque is large, it is suggested that the machine installed in the concrete foundation, there are embedded on the basis of safety when welding weldment to install, based on depth and area calculated separately according to soil conditions, it is recommended that basis weight is roughly three times of the weight of the machine, machine installation dimensions refer to basic map.

2. Installation in place, you should check whether gear reducer shift, tanks and large bucket wheel clearance is consistent, after adjusting, welding machine fixed on the foundation.

3. Fill lubricating oil, adjust the oil level, and generally 50% below the center axis is appropriate.

4. After proper installation and adjustment of the machine, make a trial run, load test should achieve:

1) 2 hours continuous operation:

2) All fasteners should be firm, without loosening;

3) reducer, gear box no unusual sound.

5. Load test in addition to achieve load test requirements, but also meet the following requirements:

1) feed, you cannot make material strong impact on the tank, and not partial load and full of feed water tank, to avoid damage to bucket wheel and the body.

2) feeding maximum amount should meet the design requirements.

vibration feeder: http://www.jaw-breakers.com/W249.html

Email This Post Print This Post

About Us

Global Freead is the no.1 advertising portal available online to easily reach worldwide customers. It is a free classified website with a wide range of visitors in internet. A Site To Post Free Buy Sell Global Classified Ads Online. Search Classified Ads For Jobs, Find Real Estate Properties On Sale and much more.