How to Determine the Wet Permanent Magnetic Separator ?
7 August, 2013 at 8:34 am in Featured
Wet magnetic separator is mainly composed of cylinder, magnetic system, tank, transmission of four parts. Cylinder is welding by the 2-3mm stainless steel plate. The cover is the Cast aluminum parts; it connects with the Stainless steel screw and barrel. The motor drive cylinder for the rotary movement through the reducer. Magnetic system is an open magnetic system and is in the cylinder. Magnets lump are installed on the plate of Magnetic Yoke by the Stainless steel. The Magnetic Yoke’s axis extends outside of the cylinder. The side of axis has the arm. Moves the arm can adjust the magnetic angle. If it is adjusted to the suitable angle, it can be fixed by the tie. The tank work area is made by the stainless steel plate. The rack and tanks’ other parts are welded by the ordinary steel.
Here, we would like to share the gap and the assay method to wet permanent magnetic separator with you.
1. The working gap of the wet permanent magnetic separator refers to the distance between the cylindrical skin and the bottom plate slurry through this gap; this gap is also the effective magnetic field effect region; its thickness may be adjusted between30 ~ 60mm.
2. The precise determination of the working gap can be done during overhaul process; put a piece of plasticine on plate at each close to both ends of the base, then installed the tank, plus a good gasket, and then put down the tank; take out the plasticine to measure its pressed thickness of the flat that is the exact value of the work gap. When take rough measurement, we can open slots on both ends of the ore holes, reach out and touch the gap, you can know these approximate values; too large or too small working gap will affect the separation indexes.
3. The suitable value of the working gap should be according to the specific production of the plant, adjustment method to add and subtract gasket on the four points of the tank body which support the rack. Because the position of the cylinder is fixed, the tank elevated after plus gasket, and working gap becomes smaller; reducing gasket can enlarger working gap. The size of the working gap should be uniform along the axial direction, if the gap sizes in both ends are different, it will cause the slurry flow rate range.Henan Hongxing Mining Machinery Co., Ltd is the professional manufacturer of complete sets of mining machinery, for example,mineral impact crusher, stone jaw crusher Welcome all of you to visit our official website.impactor equipment: http://www.hxjqcrusher.com/Impact-crusher.html