Preheat two starts bending machine dies song
11 November, 2014 at 2:06 am in Auto
Preheat two starts bending machine dies song: idling, test run Many mechanical devices need to be at the beginning of the preheating period of time. Such failures can be ruled out in advance that appears, the next job creation a good state for equipment and staff. press brake tooling Is the same. After start-up, the need for preheating, preheating is divided into two steps: idling and test run. The following is a specific description. Idling. In the boot device, it must first be preheated, that started when the first idle a few minutes, so make enough machines to clear the last legacy of a better job, while some machines stopped, there will be some cases, the plate is not idling when the first problem is to prevent sudden, without causing damage to the people and material, this process appears to be optional, but it plays a very important role, must not neglected. Test run. In addition to idling, the other on the board when it should also pay attention to the top of the slider and from running a few times, although the main part of the slider is not directly machined parts, but if it is not a normal phenomenon occurs also for machine or material cause some damage, because the slider in order to achieve synchronization and machine, the machine must be a good fit in terms of speed and rhythm of the above, and this dry run state, just to make it a good test, the slider poles and machine if you can not match, bending machine tool can also cause damage, during operation, if the sound is not normal to appear instantly stopped.