The Inimitable and Invincible Performance Characteristics of Sand Maker
8 October, 2012 at 6:36 am in Computer
Sand machine and the impeller is a sand maker important part, it is a part of the machine, and also the most vulnerable. Since the completion of the distributed emission materials in the impeller, it is possible material to wear impeller and improper operation. Therefore, in the course of their work, to pay special attention of preventing an accident because of negligence in the production process is one important thing. We know that the head of the shaft to the top of the spindle assembly installed on an impeller of the sand maker. The impeller tapered sleeve joints and keys provides for a high-speed rotating torque. The broken material from entering the center of the impeller can be discharged. The upper impeller through the center of the material distributors is the same too.
An impeller is a rotating component of a centrifugal pump, usually made of iron, steel, bronze, brass, aluminum or plastic, which transfers energy from the motor that drives the pump to the fluid being pumped by accelerating the fluid outwards from the center of rotation.
Under normal circumstances, the transmitted most of the sand pot use of a single motor or a motor-driven belt transmission mechanism. Sand maker dual motor drive install on both sides of the spindle assembly of the two electric motors. The pulleys of the two motors are connected by the belt and the spindle pulley to ensure that the spindle the stressed balance processing on both sides without the additional torque.
The material is uniformly distributed in the fabric at the center of the cone body sand maker impeller to the all Release wrenches. The wear blocks made from special materials to install the launch of the exit of the runner can be replaced. Impeller material is accelerated to a certain speed projectile. The material lining whirl crushing chamber strongly self-crushed material impact. Cone hat and the impeller in the flow path between the plates of the upper and lower parts of the sand maker are the wear amount of the block, so as to prevent it from wear and tear equipped. Stop running on the device, you should pay attention to the first stop feeding, and then stopping the discharge device. The feed should be continuous and uniform. Material specifications should strictly abide by the relevant provisions. Otherwise, sand maker can be worn easily, because the material of the impeller.
If one heats a pot of soup on the stove the pot will develop a temperature gradient, (warmest on the bottom and cooler at the surface). Mild agitation will increase the rate of heating by dissipating the heat through the entire pot. Even more significant, agitation disturbs the soup directly contact with the hotter pot surface.As the professional manufacturer of complete sets of mining machinery, such as crusher,impact crusher, Henan Hongxing is always doing the best in products and service.
cement making production line:http://www.hx-crusher.com/cement_production_line.html