The Installation and Start of Mining Hammer Crusher
15 June, 2013 at 6:28 am in Real Estate
The hammer crusher is important machinery equipment in China, and it is mainly suitable for crushing medium hardness and brittle materials, and it is widely used in the cement, mining, coal preparation, power generation, chemical industry, building materials industry. Hammer crusher is characterized by big feed size and crushing ratio, high efficiency, uniform particle size, easy maintenance and little wear.
The large-scale one-stage hammer crusher produced by Hongxing Mining Machinery is suitable for crushing the mixture of the limestone and clay and it also can be used for crushing the coal. The large lumps of ore can be once crushed to the required granularity into the mill. In this way, the traditional two-stage crushing is replaced. The process is simplified and the production cost is reduced. The one-stage hammer crusher is mainly used in cement production line, large sand and gravel aggregate production line and other projects.
Following Hongxing machinery will make introduction on the installation and commissioning process of hammer crusher. Correct installation and reasonable debugging have great significance for the normal use of the crusher equipment and extending the life cycle. If you start various equipment installations, you should correct the relative position of each device on the basis of the requirements, and pouring the anchor bolts. After anchor bolts is fixed on the ground, proofing device, fastening bolts.
Installation of electrical equipment should be installed in accordance with the relevant technical requirements, installation location should be easy to operate and always observe all kinds of instruments. The resistance among a variety of electrical equipment on the ground should be not less than 1.0MΩ, the insulation resistance between motor and ground shall not be less than 0.8MΩ. Examine all rotating parts, each rotating parts should be flexible rotation, there should be no bump, the blocking phenomenon, and it should be good lubrication.
Start the motor of hammer mill to determine that the rotation direction of the motor should be consistent with the rotation direction indicator, install the V-belt, regulate the tension of the V-belt,. The equipment should be started without load. Normal start, it must be approved by the idle time idling, and then begin order production.
rotary screener: http://www.china-hxjq.com/p126.html